- Messages : 106
- Karma: 3
- Remerciements reçus 2
arrête vives dans T spline
- onlyforpeace
- Auteur du sujet
- Hors Ligne
- Expert Boarder
-
Réduire
Plus d'informations
il y a 4 ans 11 mois #178
par onlyforpeace
arrête vives dans T spline a été créé par onlyforpeace
je suis en train de tester T SPLINE, pour de la retroconception,il y a des outils qui ont l'air pratique, mais je ne sais pas me servir de T spline...
quand je créer des surface T spline, puis que je les extrudes avec le bouton Alt, il me sort un volume avec des arêtes vives et non en continuité de courbure... je cherche l'endroit ou on règle cette continuité entre face, mais je ne trouve pas...
une idée?
quand je créer des surface T spline, puis que je les extrudes avec le bouton Alt, il me sort un volume avec des arêtes vives et non en continuité de courbure... je cherche l'endroit ou on règle cette continuité entre face, mais je ne trouve pas...
une idée?
Connexion pour participer à la conversation.
- Joao
- Hors Ligne
- Modérateur
-
Réduire
Plus d'informations
- Messages : 16
- Karma: 2
- Remerciements reçus 4
il y a 4 ans 11 mois - il y a 4 ans 11 mois #179
par Joao
Réponse de Joao sur le sujet arrête vives dans T spline
Hello,
I am writing in English as it´s easier for me. If you don´t understand the text I can try later in French.
,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,
Unfortunately, in the last version of Tsplines, "creases" are on by default when doing an extrusion. Some complaints on this have already been voiced.
That means that instead of a nice round shape when doing an extrusion of surfaces, you get sharp corners !
Run "tsRemoveCreases" in the comand line and select the object or right click on the button as in the attached image.
Hope this helps
Regards
Joao
I am writing in English as it´s easier for me. If you don´t understand the text I can try later in French.
,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,
Unfortunately, in the last version of Tsplines, "creases" are on by default when doing an extrusion. Some complaints on this have already been voiced.
That means that instead of a nice round shape when doing an extrusion of surfaces, you get sharp corners !
Run "tsRemoveCreases" in the comand line and select the object or right click on the button as in the attached image.
Hope this helps
Regards
Joao
Dernière édition: il y a 4 ans 11 mois par Joao.
Connexion pour participer à la conversation.
Temps de génération de la page : 0.134 secondes